You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
This is a ZX-M100-24G motion sensor (v1.2)
The device appears in ZHA but only the status of the firmware is shown, not any of the sensors or configuration. There are a few quirks available for different versions of the same device, some of the controls work but haven't managed to get everything working.
Problem description
This is a ZX-M100-24G motion sensor (v1.2)
The device appears in ZHA but only the status of the firmware is shown, not any of the sensors or configuration. There are a few quirks available for different versions of the same device, some of the controls work but haven't managed to get everything working.
Solution description
Add support for the device in ZHA.
Screenshots/Video
Screenshots/Video
[Paste/upload your media here]
Device signature
Diagnostic information
Diagnostic information
Logs
Logs
Custom quirk
Custom quirk
Additional information
No response
The text was updated successfully, but these errors were encountered: